A light bar can draw more current than a dashboard switch should carry. A relay lets a small switch signal control a big circuit straight from the battery. It is the standard way to wire any high-draw light, and it is what keeps wires from melting.
Key takeaway: fuse the power wire close to the battery, let the relay carry the load and let the switch only trigger it.
What you need
- A 4-pin relay with the common 30/85/86/87 layout, rated for the load.
- An in-line fuse holder and a fuse sized to the lights and wire.
- Wire gauge matched to the current and the length of the run.
- A switch, a ground point and weatherproof connectors.
How to wire a light bar with a relay
- Disconnect the battery. Always start here.
- Run power to terminal 30. Use a fused wire from the battery positive, with the fuse near the battery.
- Connect terminal 87 to the light bar. This is the switched high-current output.
- Connect terminal 86 to the switch. The switch gets power from an ignition-switched or accessory source, and it only has to carry a tiny current.
- Ground terminal 85. Use a clean bare-metal ground.
- Ground the light bar, seal connections and secure the wiring away from heat and moving parts.
What goes wrong most often?
- A fuse that is too big or missing.
- Thin wire that heats up.
- A bad ground.
- Water in the connectors. See LED light waterproof ratings.
We do a lot of these. Our rock light wiring guide uses the same principles. For a professional install, see our lighting guide.
Do I always need a relay for a light bar?
For most bars, yes. It protects the switch and gives full power to the lights.
What size fuse should I use?
Match it to the light's rated current with a margin, and follow the manufacturer's kit instructions.
Can I tie into the high beams?
Some people do, but it makes the light bar come on with the high beam, which can be a problem on public roads.
Sources
- Rigid Industries, installation resources
- Baja Designs, installation resources